Figure B-16. Base Unit/Hard Disk Label On T1000 As Chassis - Tekelec T1000 Hardware Manual

How to Locate T1000 AS Part Numbers

Figure B-16. Base Unit/Hard Disk Label on T1000 AS Chassis

• Base chassis part number, serial number, and CLEI (in the middle of label)
• Software applications (at the left side of label)
• Part number, serial number, and CLEI for both Hard Disk A and Hard
Disk C (at the right side of label). Report whether the replacement chassis
is to also contain replacement hard drives.These numbers are needed in
either case:
— If the replacement chassis does not need to contain replacement hard
— If the replacement chassis does need to contain replacement hard disk
7.
To ensure that the replacement chassis has the same memory configuration as
the failed chassis, supply all the requested information from the stickers on
the memory label (see Figure B-17).
B-20
disk drives, Tekelec manufacturing will use these numbers to create
the new base unit/hard disk label and apply it to the replacement
chassis
drives, Tekelec manufacturing will use these numbers both to install
replacement hard disk drive assemblies in the chassis and also to
create the new base unit/hard disk label and apply it to the
replacement chassis
03_ts_chassis_config_label
910-0095-001 Revision J November 2007