Introduction; How To Unpack The T1000 As Frame And Conduct Inventory; How To Install A T1000 As Frame - Tekelec T1000 Hardware Manual

Introduction

Introduction
This chapter describes how to unpack and install in a DC environment a
heavy-duty frame that contains from one or more T1000 AS units and associated
equipment.
For information about installing a T1000 AS unit in an AC environment and about
installing an additional T1000 AS unit into a heavy-duty frame that already
contains from one to four T1000 AS units, see Chapter 5, "How to Install
Hardware in an Existing Frame."
NOTE: The total number of T1000 AS units allowed in a frame depends on
the application. For more complete information about the maximum
configuration allowed by the application, refer to the

How to Unpack the T1000 AS Frame and Conduct Inventory

When the T1000 AS hardware system frame arrives, perform the following
procedure:
Procedure 4-1.
1.
Unpack the heavy-duty frame, using the procedure described in 822-0094-02.
2.
Ensure that all the parts listed on the packing list have been received.
3.
Ensure that the part numbers on the labels on the left and right sides of each
T1000 AS unit match the sales order for each of the following categories:
• Base configuration for hard disk
• Installed memory information
• PCI card configuration
For information about the fields on a label, see "T1000 AS Chassis Part
Number Information" on page B-16.
4.
Be sure to return the frame's shipping container, as described in 822-0094-02.
5.
This procedure is complete.

How to Install a T1000 AS Frame

A Heavy Duty (HD) frame is a specific Tekelec frame that has a specific footprint.
It should not be confused with other 19- or 23-inch standard frames.
4-2
How to Unpack Frame and Conduct Inventory
DC assembly
910-0095-001 Revision J November 2007
drawing.