How To Replace T1000 As Frus; How To Replace An Air Filter - Tekelec T1000 Hardware Manual

How to Replace T1000 AS FRUs

13.
Replace any plastic panels and doors that were removed.
14.
This procedure is complete.
Next, turn the power back on as described in "How to Power Up" on
page 6-14the application manual.
How to Replace T1000 AS FRUs
Use one of the following procedures in this section to replace a T1000 AS FRU:
• Procedure 7-8, "Replace Air Filter," on page 7-18
• Procedure 7-9, "Replace a Fan Assembly," on page 7-20
• Procedure 7-10, "Replace a Hard Disk Drive Assembly," on page 7-24
• Procedure 7-11, "Replace a Removable Media Disk Drive Assembly," on page
7-34
• Procedure 7-12, "Replace a PCI Card," on page 7-37
• Procedure 7-13, "Replace a T1000 AS Chassis FRU," on page 7-43

How to Replace an Air Filter

It is recommended that the air filter on the T1000 AS chassis be replaced at least
once a month. Before beginning this procedure, ensure that a spare filter is on
hand. If the number of spare filters is running low, order additional filters.
NOTE: It is not necessary to slide out or remove the T1000 AS chassis from its
frame in order to replace the filter.
SHOW ME: To view a video (with sound) that shows some steps of the
following procedure, click here. For personnel safety, be sure to read all the
steps in the following procedure. For more information about how to view this
video, see "Programs Needed to View Linked Documents" on page 1-4
Procedure 7-8.
WARNING:
frame when working on electronic components.
7-18
Replace Air Filter
Always wear an ESD wrist strap grounded to the bench or
910-0095-001 Revision J November 2007