1.
From the front of the frame, remove the # 12-24 Phillips screw from each
chassis retention bracket (see Figure B-2). Do not remove the screws in the
frame adapter brackets.
Figure B-2. T1000 AS Chassis Front View
Chassis Retention
Brackets (Remove these Screws)
2.
From the front of the frame, using the handles on the front top cover of the
chassis, pull forward until the release buttons on the inner arms of the slide
assemblies pop into the holes on each side.
DANGER: If the T1000 AS chassis is pulled too far out after the release
buttons are disengaged, the inner slide members (attached to the chassis)
could come out of the middle slide members (attached to the frame).
3.
Using a Phillips screwdriver, loosen the captive spring-loaded screws on the
T1000 AS chassis top cover until they are free. See Figure B-6 for locations.
910-0095-001 Revision J November 2007
Handles
Captive Cover Screws
How to Locate T1000 AS Part Numbers
(Do NOT Remove
These Screws)
B-5