Figure 4-6. Anchor Assembly For Use With Support Channel - Tekelec T1000 Hardware Manual

How to Install a T1000 AS Frame

Figure 4-6. Anchor Assembly for Use with Support Channel

Note: When an anchor assembly is used on a raised floor, the anchor
assembly must be disassembled and the correct length of threaded rod of the
proper diameter must be used for the floor height requirement. Finger tighten
any nuts above raised floor before tightening nuts below raised floor
Large steel washer
Fiber washer
Nylon shoulder
washer
Threaded rod
(see note)
Large steel washer
Small steel washer
Procedure 4-6.
1.
Ensure that Procedure 4-3, "Create Cable and Anchor Holes for Raised
Floors," on page 4-5 has already been performed.
2.
For each threaded rod, thread the following components in the order shown
onto one end of the rod (these components are threaded on the rod while the
rod is upside down; see Figure 4-6 on page 4-14 to identify the components
and their orientation):
a.
5/8 inch nut
b.
Small steel washer
c.
Large steel washer
3.
From underneath the raised floor, insert the threaded rod/anchor assembly
through the support channel, the raised floor, the isolator pad, and the frame
floor.
4-14
Anchor
Raised Floor
Small steel washer
Anchor Frame to Raised Floor with Support Channel
Torque nut
(red plastic cover)
Frame floor
Isolator pad
Raised floor
Support channel
(example Unistrut)
5/8 inch nut
910-0095-001 Revision J November 2007
Frame floor
Raised floor
Concrete floor
04_raised_floor_anchor_unistrut
Support channel
(example Unistrut)
End view