Breaker Panel; Figure 30: T1100 As With Side Cable Management Arms; Figure 31: Front Of Breaker Panel - Tekelec 1100 Hardware Manual

T1100 AS Hardware System Overview
Dimension
1. Tekelec makes no warranties for servers that are installed without properclearances or that
are removed from Tekelec-standard frames.
2. The Tekelec 1100 AS enclosures should be free to slide only duringinstallation, service, or
repair; they should be locked down at all othertimes.
Cable Management Arms
TheT1100 AS is installed on slides for easy access. When the chassis is slid in or out, strain on the
cables is relieved by side cable management arms. These cable management arms are attached to
the sides of the frame and fold inward towards the back of theT1100 AS it is slid out from the
frame (see

Figure 30: T1100 AS with Side Cable Management Arms

that is shipped with these cable management arms also includes tension bars that are mounted
on the rear of the server to further reduce strain on the cables.
Figure 30: T1100 AS with Side Cable Management Arms

Breaker Panel

Breaker panels are used to provide redundant power paths toT1100 AS units and other equipment
in a heavy duty frame in a DC environment.

Figure 31: Front of Breaker Panel

The breaker panel has two sides: side A and side B. Each side has twelve breakers, although only
certain breakers on each side are active (closed). The open position of each breaker is marked by
"O" and "|" marks the closed position.
Figure 31: Front of Breaker Panel
46
Value
on page 46 shows a breaker panel.
Hardware Manual
Notes for Rack-Mounting
on page 46). AT1100 AS chassis
910-2969-001 Revision K, June 2009