Table of Contents
Advertisement
Figure B-9. Base Unit/Hard Disk Label on T1100 AS Chassis
Procedure B-4. How to Locate serial numbers for Hard Disk Drive Assembly
1.
Request that the Customer Care Center assist you in determining whether the
hard disk drive assembly that needs to be replaced is in position "A" or
position "B".
2.
Determine whether the required Hard Disk area (A or B) of the base
unit/hard disk label on the front of the left side of the T1100 AS chassis can be
viewed from the side of the frame without sliding the chassis out from the
frame. See Figure B-8 for the placement of the label on the chassis and
Figure B-9 for the location of the Hard Disk information on the label.
3.
If the necessary Hard Disk area of the base unit/hard disk label shown in
Figure B-9 on page B-10 can be viewed, report the requested information from
the label, and skip to step 7. Otherwise, perform the remaining steps.
WARNING:
frame when working on electronic components.
4.
You do not need to slide the chassis from the frame to examine the hard drive
labels. From the front of the frame, unscrew the knurled screws on the sides of
the chassis and unlock the front pane (see Figure B-1).
B-10
Preliminary
Always wear an ESD wrist strap grounded to the bench or
Hardware Repair and Return
03_t S1100_chassis_config_label
910-2969-001 Revision H, February 2007
B
B
Advertisement
Table of Contents
