Figure 1: T1100 As Chassis Front View; Figure 2: T1100 As Front Top Cover Screws - Tekelec 1100 Hardware Manual

Hardware Manual
Fan Assembly Part Number Information
The part number information for fan assemblies is located only on the labels on the fan assemblies.
This procedure provides instructions about how to access these labels.
WARNING: Always wear an ESD wrist strap grounded to the bench or frame when
working on electronic components.
1. From the front of the frame, remove the # 12-24 Phillips screw from each chassis retention
bracket (see

Figure 1: T1100 AS Chassis Front View

Do not remove the screws in the frame adapter brackets.
Figure 1: T1100 AS Chassis Front View
2. From the front of the frame, using the handles on the front top cover or knurled screws on the
side of the chassis, pull forward until the release buttons on the inner arms of the slide assemblies
pop into the holes on each side. Be careful to not disconnect, bind, or pinch any cables.
DANGER: If theT1100 AS chassis is pulled too far out after the release buttons
are disengaged, the inner slide members (attached to the chassis) could come out
of the middle slide members (attached to the frame).
3. Using a Phillips screwdriver, loosen the screws on theT1100 AS chassis front top cover until
they are free.
See

Figure 2: T1100 AS Front Top Cover screws

Figure 2: T1100 AS Front Top Cover screws
910-2969-001 Revision K, June 2009
on page 15).
on page 15 for locations.
About This Manual
15