Table of Contents
Advertisement
Hardware Repair and Return
9.
Adjust the chassis retention brackets on the front of the T1100 AS chassis to
contact the frame adapter brackets when the chassis is positioned correctly in
the frame.
10.
Secure the chassis with one # 12-24 screw in the chassis retention brackets on
each side.
11.
This procedure is complete.
Hard Disk Drive Assembly Part Number Information
The part number information for hard disk drive assemblies is located on both of
the following labels:
• Label on the hard disk drive assembly (see Figure 7-11 on page 7-30).
Use this label during replacement of the part to verify that the correct part
number was ordered (see Procedure 7-9, "Replace a Hard Disk Drive
Assembly," on page 7-26).
• The Base Unit/Hard Disk Drive Label on the outside of the T1100 AS chassis.
Figure B-8 shows where this label is located and Figure B-9 shows a closeup
view of a label. Use this label when requesting an RMA. Procedure B-4 on
page B-10 provides instructions about how to access view this label.
Figure B-8. T1100 AS Chassis Label Locations
910-2969-001 Revision H, February 2007
Preliminary
B-9
Advertisement
Table of Contents
