Figure 7-23. Left Slide Member Mounting - Tekelec 1100 Hardware Manual

Field Replaceable Units
WARNING: This procedure CANNOT be performed while the T1100 AS
chassis is powered on. Never power OFF a T1100 AS chassis until the
application software and platform operating system (OS) are shut down. If
possible, use the procedures in the application manual for a "soft
shutdown." If the application interface is not operating or is not accessible,
a hard shutdown (turning OFF the breakers) is sometimes required. Contact
the Customer Care Center before doing a hard shutdown.
5.
Shut down the server.
6.
Remove the failed T1100 AS chassis from the frame using Procedure 7-4,
"Remove a T1100 AS Chassis from Frame," on page 7-12.
7.
Using a # 3 Phillips screwdriver, remove the four # 10-32 screws that attach
each inner slide member to the chassis and set the slide members aside.
NOTE: Observe the orientation of the inner slide members with the roller
bearings outward and the center tabs toward the front of the chassis. The
inner slide members are attached to the replacement T1100 AS chassis in
step 8.

Figure 7-23. Left Slide Member Mounting

910-2969-001 Revision H, February 2007
Release
Button
Four #10-32
Phillips Screws
Inner Slide Member
DRAFT
Roller Bearings
Chassis Retention
Bracket
Chassis
Center Tab
7-47