Figure 84: Left Slide Member Mounting - Tekelec 1100 Hardware Manual

Hardware Manual
WARNING: This procedure CANNOT be performed while theT1100 AS chassis
is powered on. Never power OFF aT1100 AS chassis until the application software
and platform operating system (OS) are shut down. If possible, use the procedures
in the application manual for a "soft shutdown." If the application interface is not
operating or is not accessible, a hard shutdown (turning OFF the breakers) is
sometimes required. Contact the Customer Care Center before doing a hard
shutdown.
6. Remove the failedT1100 AS chassis from the frame using
a Frame on page 108.
7. Using a # 3 Phillips screwdriver, remove the four # 10-32 screws that attach each inner slide
member to the chassis and set the slide members aside.
Note: Observe the orientation of the inner slide members with the roller bearings outward
and the center tabs toward the front of the chassis. The inner slide members are attached to
the replacementT1100 AS chassis in

Figure 84: Left Slide Member Mounting

8. Attach inner slide members on both sides of the replacementT1100 AS chassis with four # 10-32
Phillips screws each.
Orient the inner slide members with the roller bearings outward and the center tabs toward
the front of theT1100 AS chassis. See
9. If the hard disk drives and/or PCI cards from the failedT1100 AS chassis need to be moved to
the replacement chassis, perform either or both of the following procedures:
a) How to Replace Hard Disk Drive Assemblies
b) How to Replace PCI Cards
10. If requested, return the failedT1100 AS chassis to Tekelec.
910-2969-001 Revision K, June 2009
Step 8
on page 135.
Figure 84: Left Slide Member Mounting
on page 118
on page 129
Field Replaceable Units
How to Remove T1100 AS Chassis from
on page 135.
135