Field Replaceable Units
See
Figure 82: Chassis Rear Top Cover Views.
Figure 82: Chassis Rear Top Cover Views.
9. Using a #1 Phillips screwdriver remove the retention screw located at the top of the PCI faceplate.
Note: If a PCI card is being added, remove the PCI filler plate. When adding or removing
cards apply the correct label to the PCI configuration label. Labels are shipped with PCI cards
indicating card type and CLEI code.
10. Remove the PCI card by grasping with both hands and lifting until the card is disconnected
from the card connector.
See
Figure 83: PCI Cards and Slot Assignments
Figure 83: PCI Cards and Slot Assignments
132
on page 132.
on page 132.
910-2969-001 Revision K, June 2009
Hardware Manual