Figure 7-21. Chassis Rear Top Cover Views - Tekelec 1100 Hardware Manual

Field Replaceable Units

Figure 7-21. Chassis Rear Top Cover Views.

9.
Using a #1 Phillips screwdriver remove the retention screw located at the top
of the PCI faceplate.
NOTE: If a PCI card is being added, remove the PCI filler plate. When
adding or removing cards apply the correct label to the PCI configuration
label. Labels are shipped with PCI cards indicating card type and CLEI
code.
10.
Remove the PCI card by grasping with both hands and lifting until the card is
disconnected from the card connector. See Figure 7-22.
910-2969-001 Revision H, February 2007
DRAFT
Cover In Place
Guide Screws
Captive
Fastener
Cover Removed
PCI Card Type/Slot
Assignment Lable
7-43