Table of Contents
Advertisement
Hardware Manual
9. Insert the new drive.
As the drive engages the connectors push the latch closed to lock the drive in position.
10. Do one of the following:
a) If this procedure is being performed to replace a failed hard disk drive, skip to the next
step.
b) If this procedure is being performed to move hard disk drive assemblies from a failedT1100
AS chassis to the replacementT1100 AS chassis, repeat
page 123 to move the other drive.
11. Close the front fascia.
12. Lock the front fascia and tighten the captive screws to secure the front fascia.
13. Do one of the following:
a) If this procedure is being performed to move hard disk drive assemblies from a failedT1100
AS chassis to the replacementT1100 AS chassis, skip to the next step.
b) If this procedure is being performed to replace a failed hard disk drive, do the following:
Attach the label that was received with the replacement hard disk drive assembly on
the base unit/hard disk label located on the front of the left side of theT1100 AS chassis
(for label placement, see
Return the failed hard disk drive assembly to Tekelec, using the shipping contained in
which the replacement hard disk drive assembly was received. Arrange the return
shipment by using the procedures described in
14. Depending on how the hard disk drive assembly was accessed in
theT1100 AS chassis to its original position using one of the following procedures:
a)
How to Slide T1100 AS Chassis Back into Frame
b)
How to Return a T1100 AS Chassis to the Frame
15. Refer to applications documentation to determine additional required steps.
16. This procedure is complete.
How to Replace Removable Media Disk Drives (CD/DVD)
Use the procedure in this section to replace the assembly that contains two removable media disk
drives (also called CD/DVD drives). This assembly is located on the left side of the chassis beneath
the front top cover.
show me: To view a video (with sound) that shows some steps of the following
procedure,
to read all the steps in the following procedure. For more information about how to
view this video, see
1. Ensure that the following have been done:
a) An RMA has been obtained (see
b) A spare removable media disk drive assembly is available.
Inspect the replacement unit and its shipping container for indications of damage. If damage
is noted, contact the project manager or report damage to the carrier. Ensure that the contents
910-2969-001 Revision K, June 2009
Figure 71: T1100 AS Chassis Label Locations
click
here. For personnel safety and to protect equipment and data, be sure
Programs Needed to View Linked Documents
Repair and Return Shipping Instructions
Field Replaceable Units
Step 5
on page 120 through
Hardware Repair and Return
Step 3
on page 107
on page 110
Step 9
on
on page 122).
on page 11.
on page 119, return
on page 4.
on page 12 )
123
Advertisement
Table of Contents
