How To Replace Hard Disk Drive Assemblies - Tekelec 1100 Hardware Manual

Application server
Hide thumbs Also See for 1100:
Table of Contents

Advertisement

Field Replaceable Units
4. With the thumb and forefinger of each hand, grasp the pins at the upper left corner and lower
right corner of the square fan assembly.
Then, while still holding the pins, pull the square fan assembly out of the chassis.
5. Insert the new square fan assembly.
Be sure to align the pins on the bottom of the assembly with the grommets in the chassis. Push
the fan assembly in until it is flush with the front edge of the chassis.
6. Swing the front fascia up and lock it.
Tighten the knurled screws on either side of the front fascia. Check to ensure the CD/DVD
drive can still eject.
7. Close the chassis front top cover and tighten the two screws on each side that fasten the cover
to the chassis.
8. Depending on how the fan assembly was accessed in
chassis to its original position using one of the following procedures:
a)
How to Slide T1100 AS Chassis Back into Frame
b)
How to Return a T1100 AS Chassis to the Frame
9. If requested, return the failed fan assembly to Tekelec.
Arrange the return shipment by using the procedures in
11.
10. This procedure is complete.

How to Replace Hard Disk Drive Assemblies

Use the procedure in this section for either of the following purposes:
118
Step 2
on page 117, return theT1100 AS
on page 107
on page 110
Hardware Repair and Return
910-2969-001 Revision K, June 2009
Hardware Manual
on page

Advertisement

Table of Contents
loading

Table of Contents