How To Return A T1100 As Chassis To The Frame - Tekelec 1100 Hardware Manual

Field Replaceable Units
Continue with one of the following procedures:
• If the chassis has been removed from the frame to a workbench in order to
replace one of the following FRUs, go the procedure shown:
— Procedure 7-8, "Replace a Square Fan Assembly," on page 7-23
— Procedure 7-9, "Replace a Hard Disk Drive Assembly," on page 7-26
— Procedure 7-10, "Replace a Removable Media Disk Drive Assembly," on
page 7-32
— Procedure 7-12, "Replace a PCI Card," on page 7-40
• If the T1100 AS chassis is being replaced, but the hard drives and/or the PCI
cards from the failed chassis are to be used in the replacement chassis, go to:
— Procedure 7-13, "Replace a T1100 AS Chassis FRU," on page 7-46
— Then go to either of both of the following procedures:
–Procedure 7-9, "Replace a Hard Disk Drive Assembly," on page 7-26
–Procedure 7-12, "Replace a PCI Card," on page 7-40
• If the T1100 AS chassis is being replaced, and it was ordered with
replacements for the hard drives and PCI cards, go to Procedure 7-13,
"Replace a T1100 AS Chassis FRU," on page 7-46.
When these procedures have been finished, return the chassis to the frame, using
Procedure 7-5, "Return a T1100 AS Chassis to the Frame," on page 7-16.

How to Return a T1100 AS Chassis to the Frame

Perform the procedure in this section when it is time to return the T1100 AS
chassis to the frame for one of the following reasons:
• A T1100 AS chassis FRU is being replaced and the following procedures have
been performed:
— Procedure 7-4, "Remove a T1100 AS Chassis from Frame," on page 7-12
— Procedure 7-13, "Replace a T1100 AS Chassis FRU," on page 7-46. One of
the following procedures may also have been performed:
–Procedure 7-9, "Replace a Hard Disk Drive Assembly," on page 7-26
–Procedure 7-12, "Replace a PCI Card," on page 7-40
• An internal FRU is being replaced and the following procedures have been
performed:
— Procedure 7-4, "Remove a T1100 AS Chassis from Frame," on page 7-12
— One or more of the following procedures:
–Procedure 7-8, "Replace a Square Fan Assembly," on page 7-23
–Procedure 7-9, "Replace a Hard Disk Drive Assembly," on page 7-26
910-2969-001 Revision H, February 2007
DRAFT
7-15