How To Return A T1100 As Chassis To The Frame - Tekelec 1100 Hardware Manual

Field Replaceable Units
6. From the front of the frame, using the handles on the front top cover or the knurled screws on
the sides of the chassis, pull the T1100 AS chassis forward until the release buttons on the inner
arms of the slide assemblies pop into the holes on each side.
7. Simultaneously depress the chassis release buttons on each side and slowly pull the chassis
forward until the chassis and attached inner slide members are completely free of the slide
assemblies.
DANGER:
Moving a T1100 AS chassis requires two people. Each T1100 AS chassis weighs
approximately 30 kg (65 lbs) and may cause personnel injury or damage to the
internal components due to shock and vibration if not handled properly.
Figure 64: Right Slide Assembly Mounting and Retention Bracket
See
the release buttons.
8. Place the chassis on a grounded bench and attach the ground wrist strap to the bench.
9. This procedure is complete.
Continue with one of the following procedures:
If the chassis has been removed from the frame to a workbench in order to replace one of the
following FRUs, go the procedure shown:
How to Replace the Square Fan Assembly
How to Replace Hard Disk Drive Assemblies
How to Replace Removable Media Disk Drives (CD/DVD)
How to Replace PCI Cards
If the T1100 AS chassis is being replaced, but the hard drives and/or the PCI cards from the
failed chassis are to be used in the replacement chassis, go to:
How to Replace aT1100 AS Chassis FRU
Then go to either of both of the following procedures:
How to Replace Hard Disk Drive Assemblies
How to Replace PCI Cards
If the T1100 AS chassis is being replaced, and it was ordered with replacements for the hard
drives and PCI cards, go to
When these procedures have been finished, return the chassis to the frame, using
a T1100 AS Chassis to the Frame

How to Return a T1100 AS Chassis to the Frame

Perform the procedure in this section when it is time to return the T1100 AS chassis to the frame
for one of the following reasons:
A T1100 AS chassis FRU is being replaced and the following procedures have been performed:
How to Remove T1100 AS Chassis from a Frame
110
on page 116
on page 118
on page 129
on page 134
on page 118
on page 129
How to Replace aT1100 AS Chassis FRU
on page 110.
on page 108
Hardware Manual
on page 111 for locations of
on page 123
on page 134.
How to Return
910-2969-001 Revision K, June 2009