Output Shaft - Honda Gold Wing GL1200D Shop Manual

TRANSMISSION/SHIFT LINKAGE
~HONDA
~Gl1200D'GL1200A
Install the spring.
Reinstall the front engine cover (Page 2-10).
Apply locking agent to the threads and torque
the 6 mm bolt.
6 mm BOLT
!t"'
r'A
NEUTRAL
STOPPER
ROlLAR STOPPER
SHIFT DRUM
JOINT
DOWEL PIN
LOCK NUT
...
DRUM STOPPER
CAM PLATE
STOPPER ARM
PUNCH MARK
on the cam plate should
The punch mark
face the outside.
Check operation of the gearShift linkage; set the
shift drum in neutral.
Check that the stopper arm is engaged with the
stopper cam plate. and the neutral stopper arm is
engaged with the drum set center.
Install the 6 mm nut and tighten.
TORQUE: 8-12 N'm {O.8-1.2 kg-m. 6-9 ft-lbJ
Install the stopper arm and neutral stopper arm on
their pivcit bolt.
Install the roller stopper and shift drum joint
aligning the dowel holes with the dowel pin.
Install the shift drum stopper cam plate and dowel
pin on the drum set center.
NOTE:
I
OUTPUT SHAFT
REMOVAL
Remove the engine from the frame; remove the rear
engine cover (Page 9·3).
Remove the access plate.
1 0-6