~HONDA
~GL1200D'GL1200A
18. STARTER SYSTEM
SERVICE INFORMATION
TROUBLESHOOTING
STARTER MOTOR
STARTER RELAY SWITCH
CLUTCH SWITCH OIOOE
SERVICE INFORMATION
GENERAL
19-1
19-1
19-2
19-5
19-5
..........
• To service the starter motor and starter clutch, the engine must
be
removed from the frame.
• For starter clutch inspection. see Section 9.
• Starter motor engagement is controlled by an electromagnetic relay which is energized by pushing the starter switch. This
closes a contact to provide battery voltage to the starter. A starter or "overrunning" clutch is used to prevent damage to
the starter armature due to "overspeed" when the engine starts. The starter remains engaged until the starter button is
released.
SPECIFICATIONS
ITEM
STANDARD
SERVICE LIMIT
Starter motor
Brush spring tension
560 6809(19.8 24.0 ezl
440 9 (15.5 ezl
Brush length
12 13
mm
(0.47 0.51
in)
7.5
mm
(0.30
in)
TROUBLESHOOTING
Starter motor will not turn
• Dead battery
•
Faulty ignition switch
• Faulty starter switch
• Faulty neutral switch
• Faulty starter relay switch
• Loose or disconnected wire or cable
• Clutch switch diode open
• Faulty clutch switch
Starter motor turns engine slowly
•
Low battery
• Excessive resistance in circuit
• Binding in starter motor
Starter motor turns, but engine does not turn
•
Faulty starter clutch
•
Faulty starter motor reduction gears
•
Faulty starter motor sprockets or chain
Starter motor and engine turn, but engine does not start
•
Faulty ignition system
•
Engine problems, see engine related sections
•
Faulty engine stop switch
18-1