~HONDA
~GL1200D'GL1200A
Pack new bearing cavities with grease and drive in
the left bearing with a bearing driver.
NOTE:
Drive the bearings in squarely with the sealed
ends facing out. Make sure they are fully
seated.
Install the distance collar and then drive in the right
bearing.
Lubricate the driven flange pin with molybdenum
disulfide grease.
Install the driven flange to the wheel hub.
Lubricate the dust seal lip with grease and install the
dust seal to the wheel hub.
Install the brake disc and tighten the bolts.
TORQUE: 27-33 N·m (2.7-3.3 kg.m, 20-24 ft·lb)
REAR WHEEL INSTALLATION
Apply molybdenum disulfide grease to the driven
flange splines.
WHEEL/STEERING
DRIVER
07749-0010000
DUST SEAL
DRIVEN FLANGE SPLINES
12-13