Honda Gold Wing GL1200D Shop Manual page 138

TENSIONER SPRING
r0\HONDA.
~
GL1200D'GL1200A
Hold the pulley with the Pulley Holder and tighten
the bolt.
TORQUE: 25-29 N·m (2.5-2.9 kg·m, 18-21 ft·lbl
Perform the following procedures before install the
timing belt, if the hydraulic tappet adjuster shim
selection is not necessary (see page 7·29}.
Hydraulic tapper adjuster air bleeding (page
7·30}.
Hydraulic tappet adjuster installation (page
7·30).
Shim and stopper plug installation (page 7·30).
Turn the crankshaft 90° counterclockwise to bring
the marking on the drive pulley to the original
position. The 'T-1" marking on the flywheel should
be aligned with the index mark on the engine case.
Install the right and left timing belt tensioners on
the engine case, and tighten the bolt just enough to
allow smooth movement of the tensioner.
NOTE:
To protect the timing belts, install the ten·
sioner springs with the ends facing towards
the engine case as shown.
CAUTION:
Do not lubn'cate the belt tensioner since oil
will
damage the timing belts. To protect the
sealed tensioner bean'ngs, do llot use solvellts
or other cleaning agents inside the frollt
timing cover.
CYLINDER HEADIVALVE
PULLEY HOLDER
07925-3710200
,
~ -
TENSIONER
SPR ING EN
D----n'C"ii1~_-7
l
TENSIONER BOLTS
7-27