Honda Gold Wing GL1200D Shop Manual page 223

CRANKSHAFT/PISTON
Apply molybdenum disulfide grease to the crank pin
bearings.
Install the right side rod assemblies into cylinders
NO.1 and 3 in their original positions as marked
before removal.
NOTE:
To prevent damaging crankshaft, slip short
sections of rubber hose over the rod bolts
before installation.
Install the pistons so that the "IN" mark
on the piston top is towards the top of
the engine.
Apply molybdenum disulfide grease to the rod cap
bearings.
I nstall the No.1 and No.3 rod bearing caps on the
correct crank pins.
CAUTION:
nle bearing caps must be installed in their
correct locations or the bearing oil crearance
may not be correct causing engine damage.
Tighten the nuts in a crisscross pattern in 2-3
steps.
TORQUE; 30-34 N'm (3.0-3.4 kg·m, 22-25 ft·lb)
Install the leh side rod assemblies for cylinders
No.2 and 4 in their or"iginal positions as marked.
NOTE:
Install the piston and connecting rod as·
semblies so that the intake "IN" marks on the
pistons and oil holes in the rods are facing the
top of the engine.
11 -1 6
rdiJ\HONDA
~GL12000'GL1200A
"IN" MARK
NUTS
OIL HOLE