Alternator Rotor/Starter Clutch - Honda Gold Wing GL1200D Shop Manual

ALTERNATOR/STARTER CLUTCH/REAR ENGINE COVER
q;
HONDA
~
GL1200D'GL1200A
Seal the circlip in the groove of the grommet with
the round edge facing towards the engine case.
Install the spacer and dowel pins on the case mating
face.
CIAClIP
DOWEL PIN
SPACER
PULSE GENERATOR CASE
BOLTS
LOCK NUT WRENCH, 17
x
27
mm
07907-MC70000
or
07907-4150000
l' .
I
t
is not necessary to remove
the bolt at the
end of the shaft. This bolt is used to turn the
crankshaft when the engine is installed in the
frame.
Do not torque the bolts in excess of 12 N·m
(1.2 kg·m, 9 ft-Ib) to prevent the case from
distortion.
NOTE:
Place the pulse generator case onto the spacer.
Install and tighten the pulse generator case bolts.
TORGUE: 8- 12 N·m (0.8-1.2 kg·m, 6-9 ft-Ibl
Hold the alternator rotor with the Rotor Holder,
and remove the rotor lock nut, plain washer. and
rotor.
NOTE:
AlTERNATOR ROTOR/STARTER
CLUTCH
ROTOR HOLDER
07925-3710100
9-6