Rear Engine Cover Installation - Honda Gold Wing GL1200D Shop Manual

ALTERNATOR/STARTER CLUTCH/REAR ENGINE COVER
REAR ENGINE COVER INSTALLATION
Check that there are no bolts, nuts and other
foreign matters inside the rotor.
Install the dowel pins and a new gasket.
NOTE:
Apply sealant to the right and left engine case
mating surface areas of the gasket surface.
~HONDA
~
GL12000·GL1200A '-'
DOWEL PINS
Install the rear engine cover and tighten the bolts
in a crisscross pattern in 2-3 steps.
TORQUE: 8-12 N'm (0.8-1.2 kg-m, 6-9 ft·lb)
Install the rotor with the cutout in the rotor aligned
with the dowel pin on the rotor shaft.
Install and tighten the rotor bolt.
TORQUE: 8-12 N'm (0.8-1.2 kg-m, 6-9 ft-Ib)
Inspect the air gap between the pulse generator
rotor and pickup.
AlA GAP: 0.40-1.10 mm (0.016-0.043 in)
Install the pulse generator cover.
Install the clutch assembly and clutch cover. (page
8-13).
9-16
DOWEL PIN
•
. , l . J
A.
PULSE GENERATOR ROTOR