Rear Engine Cover Assembly - Honda Gold Wing GL1200D Shop Manual

r0\HONDA
®GL1200D'GL1200A
REAR ENGINE COVER ASSEMBLY
ALTERNATOR/STARTER CLUTCH/REAR ENGINE COVER
DRIVER
Drive output shaft and pulse generator drive shaft
bearings into the case.
Output shaft bearing:
• Driver 07749-0010000
• Attachment. 52 x 55 mm 07746-0010400
• Pilot, 25 mm 07746-0040600
Pulse generator drive shaft bearing:
• Driver 07749-0010000
• Attachment, 32 x 35 mm 07746-0010100
• Pilot, 15 mm 07746-0040300
OIL SEAL
Drive in new oil seals.
OIL SEAL
Route the stator wires through the hole in the rear
engine case; install the grommet so that the groove
is seated over the edge of the hole in the engine
case.
Coat the stator mount screw threads with locking
agent and tighten the stator and plate with them.
TORQUE: 8- 12 N'm (0.8-1.2 kg.m. 6-9 ft·lb)
SCREWS
STATOR
9-5