Honda Gold Wing GL1200D Shop Manual page 242

WHEEL/STEERING
Apply contact cement
to
the left handlebar grip and
push it into place.
Apply grease to the choke lever sliding surfaces.
Insert the choke cable end into hole of the choke
lever.
Loosely install the clutch master cylinder holder
and bolts.
~HONDA
~GL1200D'GL1200A
CHOKE LEVE_.R . ...
p ._ _
CABLE END
Align the gap between the holder and master
cylinder with the punch mark on the handlebar.
Tighten the upper bolt first, then the lower bolt.
Insert the pin on the bottom half of switch assem·
bly into the hole in the handlebar.
Tighten the forward screws first, then tighten the
rear screw.
Connect the clutch switch wires.
UPPER BOLT GAP PUNCH MARK
PIN
HOLDER LOWER BOLT
Tighten the throttle cable lock nuts.
12-18
LOCK NUTS