Carburetor Installation; Float Level Inspection - Honda Gold Wing GL1200D Shop Manual

FUEL SYSTEM
Install the dowel pins and new seal rings to the
carburetor mating surfaces.
Install the carburetors and flame trap to the air
chamber.
Connect the choke and throttle linkage.
FLOAT LEVEL INSPECTION
With the float valve seated and the float arm just
touching the valve, measure the float valve with the
float level gauge.
Adjust if necessary by bending the float arm care-
fully.
FLOAT LEVEL: 7.5 mm (0.30 in)
CARBURETOR INSTALLATION
Install the intake pipes on the carburetors but do
not tighten the hose clamps until the complete
system is installed on the engine.
Install the cover on the air chamber.
NOTE:
Install -the cover with "FRONT" mark facing
forward.
4-14
rAiff\
HONDA
~GL1200D'GL1200A
FLAME TRAPS
"FRONT" MARK