CYLINDER HEADIVALVE
Remove the five rocker arm holder bolts, then
remove the rocker arm assembly and camshaft.
Mark each holder to identify what side it is on.
NOTE:
To
prevent cocking the camshaft holder
assembly, unscrew the camshaft holder bolts
in a crisscross pattern, two turns at a time.
CAUTION:
Do
I/ot
let the camshaft fall out of the
cylinder head.
CAMSHAFT INSPECTION
Inspect
the
cam
bearing surfaces for scoring,
scratching, or damage caused by insufficient lubri·
cation. Check that the oil passages are clear.
Bolt the camshaft holder in place and torque the
bolts.
TORQUE: 18-22 N·m (1.8-2.2 kg·m. 13-16 ft·lb)
Measure and record the 1.0. of each bearing.
If the bearing is worn so that the service limit is
exceeded, replace the cylinder head and camshaft
holders as a set.
SERVICE LIMITS:
Center: 25.05 mm (0.986 in)
Both ends: 27.05 mm (1.065 in)
7-6
~HONDA
~GL1200D'GL1200A
CAMSHAFT HOLDER