Angle Sensor Resistance; Angle Sensor Sub·wire Harness; Control Unit Replacement - Honda Gold Wing GL1200D Shop Manual

LIGHTS/SWITCHES/INSTRUMENTS
~HONDA
~GL1200DoGL1200A
ANGLE SENSOR RESISTANCE
GIW
BIIY
w
/
TO ANGLE SENSOR
Measure the resistance of the angle sensor at the
angle sencor coupler or connectors.
RESISTANCES:
Between Slack/Yellow and GreenfINhite:
10-19 Kf!
Between White and Green/White:
Resistance should increase steadily when front
wheel is turned slowly from left to right
(resistance should not change suddenly)
ANGLE SENSOR SUB·WIRE HARNESS
Remove the angle sensor from the steering stem.
Check the continuity, end to end, for each wire.
Between same colors: Continuity
Between different colors: No continuity
BIIY
w
GIW
3~~~---':':::~---~-
;
-----,
---
BIIY
CONTROL UNIT REPLACEMENT
Replace the control unit with a new one if the turn
signal switch is still not cancelled automatically.
Remove the air cleaner case and air cleaner element
holder.
Place a rag or shop towel over the air chamber to
prevent entry of foreign particles.
Remove the ignition control unit and relay bracket.
Remove the ignition coil.
BOLTS
IGNITION COILS
19-24