Metal Brake Lines - Honda Gold Wing GL1200D Shop Manual

~HONDA
~
GL12000'GL1200A
METAL BRAKE LINES
REMOVAL
Remove the seat, top compartment and fuel tank.
Drain the brake fJuide from the brake system.
Disconnect the metal line from the rear master
cylinder.
Remove the clamp and hose clip from the metal
lines.
Remove the rear caliper metal line.
Remove the air cleaner case and ignition coil.
Disconnect the metal line from the rear master
cylinder.
Disconnect the metal line from the front brake
hose. Remove the metal line.
HOSE JOINT
BRACKET
,
METAL LINE
HYDRAULIC BRAKES
HOSE CUP
8
METAL LINE
JOINT NUT
INSTALLATION
Connect the metal line to the brake hose. Tighten
the joint nut to the specified torque.
TORQUE: 16-18 N·m (1.6-1.8 kg·m. 12-13 ft-Ibl
NOTE:
Be careful not to twist the metal lines when
tightening.
15-21