Honda Gold Wing GL1200D Shop Manual page 199

TRANSMISSION/SHIFT LINKAGE
Install the shift drum in the engine case.
Check the markings on the shift forks:
• Leh fork: Face the mark "l" towards the rear
of the engine. Engage the claw with the C5 gear,
and the guide with the shift drum groove.
• Center fork: Face the mark "C" towards the
rear of the engine with the guide engaged with
the shift drum groove.
Liberally apply clean engine oil to the shift fork
shaft.
Slide the shift fork shaft into the engine case and
push through the left and center shift forks with the
short end (as measured from the lock bolt hole)
facing towards the inside.
• Right fork: Face the mark "AU towards the
front of the engine. Engage the claw with the C4
gear, and the guide with the shift drum groove.
Engage the right shift fork with the C4 gear and
shift drum as described above.
Push the shift fork through the right shift fork
aligning the lock bolt hole in the shaft with the
lock bolt hole in the shift fork.
SHIFT DRUM
SHIFT FORK SHAFT
~HONDA
~Gl1200D'GlI200A
'-'
SHIFT FORK MARKS
SHIFT FORK MARK
,
Install the lock washer and lock bolt on the right
sifht fork and tighten.
TORQUE:
14-18
N·m
(1.4-1.8
kg·m.
10-13
ft·lb)
Bend the tab of the lock washer up against the lock
bolt.
Install the shift drum set plate on the end of the
shift fork shaft and tighten the bolt.
TORQUE:
10-14
N·m
(1.0-1.4
kg.m.
7-10
ft-Ib)
NOTE:
Insert a 6 mm bolt in one of the bolt holes
in the set plate to align the bolt holes.
Reassemble the shift drum linkage (Page
10·5).
10-20
LOCK HOLE
6
mm BOLT