Honda Gold Wing GL1200D Shop Manual page 137

CYLINDER HEADIVALVE
r:::iJ\
HONDA
~GL1200D'GL1200A ~
Place the nil".:" gasket on the cylinder head.
Check that the neutral switch wire is routed cor-
rectly, then install both heat shields.
NOTE:
To ensure proper alignment, run a cover bolt
into the heat shield hole before torque the
t\.\10
shield bolts.
Check that both timing belt drive pulleys are tight.
NOTE:
If the bolt is properly torqued and one or
both of the pulleys is loose, disassemble and
inspect pulley keyways for wear.
GASKET
70-80 N'm
(7.0-8.0
kg-m,
51-58
ft-Ib)
RIGHT
TIMING BELT COVER BOLT
KEY WAYS
LEFT
. ~
Install the woodruff key in the keyway in the cam·
shaft.
Install the driven pulley on the camshaft with the
key in the camshaft aligned with the keyway in
the driven pulley.
NOTE:
The right pulley should he installed so that
its boss is facing outward, and the left pulley
with its boss facing inward.
CAUTION:
Do not tum the camshaft while timing belts
are removed; you may damage the valves and
piston domes.
7-26
BOSS WOODRUFF KEY