Tachometer; Air Pressure Gauge; Gear Position Indicator - Honda Gold Wing GL1200D Shop Manual

L1G HTS/SWITCH ES/I NSTRUMENTS
TACHOMETER
If the tachometer does not indicate engine speed
properly. check for continuity between the Yellowl
Blue terminals of the meter white 4-P coupler and
.;:::1.2 ignllion coil, and Yellow/Green terminal and
Blue/Yellow terminal of the.;(.).4 ignition coil.
If there are continuily. check for loose or im-
properly connected meter wires in the meter unit.
Rep ace the meter unn with a new one if the wires
are
connecl~d
properly.
AIR PRESSURE GAUGE
Connect a hand pressure pump to the air pressure
sensor Inlel. With lhe ignllion switch ON, gradually
apply pressure to the sensor by operating the pump.
Check the pressure sensor if the pressures applied
to the sensor do nOI agree with the pressures indi-
cated on the pressure gauge (Page 13·26).
Check the wire for loose or poor connection if the
sensor
IS
normal. Replace the L.C.D. unit with a
new onl! if necessary.
GEAR POSITION INDICATOR
Disconnect the black G·p coupler from the meter;
turn on the ignition switch.
Check lor correct indication in each gear position
by grounding the coupler terminal as shown.
Gear position
1
N
2
3 4
5
Color cocle Y Lg!R
.' I Y
W!Bu
RNi
G/O
If
the indicator displays properly, check the shjft
sensor (Page 19-14).
If the shift sensor is good. check for loose or poorly
connected with or connection.
nection.
Replace the loC.D. unit with a new one if necessary.
19-26
U\HONDA
~Gl1200D'Gl1200A
Y!Bu
r
~
:c-
o
.~
I
q
Y/G
Y/G
PRESSURE SENSOR
....
BLACK 6P COUPLER