Honda Gold Wing GL1200D Shop Manual page 157

CLUTCH
~HONDA
~GL1200D'GL12DOA
Remove the clutch center
ammbly
from the clutch
outer without disturbing the alignment.
Slide the clutch center assembly
outer to align the discs and plates.
into the clutch
LOGK NUT
--
OIL SEAL DRIVER ATTACHMENT
07965-MA10200
STOPPER RING
LOCK TAB
LOCK WASHER WASHER
Install the lock tab washer with the stopper tab
aligned with the bo~ of the clutch center.
Install the center lock nut with the taper end facing
towards the inside.
Install the clutch center assembly in the clutch
outer.
Install the lock washer with the marking "OUT-
SIDE" facing out.
Place the diaphragm spring on the clutch center and
compress the spring in a press just enough to install
the stopper ring.
To prevent
Q
loss of tension, do not compress
the diaphragm spring more than necessary to
installrhe stopper ring.
CAUTION:
Seat the stopper ring in the ring groove in the clutch
center boss with the sharp end facing up.
8-14