Updating Main Firmware - MUTOH Valuevet VJ-628X Maintenance Manual

4.3 Working with MUTOH Service Assistance Software
4.3.7

Updating main firmware

The following describes the procedure to update main side firmware accessed to Technician
mode without replacing Main board Assy.
NOTE
Before this procedure, make sure to prepare the following:
• Set up the printer, computer and MSA.
"4.3.3Required Environment
• Start the printer on Board manager mode.
"(6)Starting the printer
• Change to Technician mode on MSA.
"(12)Switching to Technician Mode
1
Click [Main F/W Update] on main
window.
2
Select and click target install file (*jfl) to
transfer ① and click [Open] ② .
* Press [Cancel] to return to the main
window.
NOTE
F/W used for updating should use the file saved on the PC locally.
It may be unable to update, if the file saved in the USB memory etc. is used.
4.3.7 Updating main firmware
3
On [Main F/W update], click [OK].
*Press [Cancel] to return to the main
window.
After clicking [OK], if any communication errors occur such as wrong IP address or
unplugged LAN cable, an error message appears. If any setting errors occur such
as inappropriate model name selection, serial number registration is not finished or
incorrect one is registered, an warning message appears.
In both cases, communication with printer shall be interrupted.
Click [OK] to return to main window.
4
While firmware transfer is in process,
[Communication situation] window
1
appears.
*Press [Stop] to stop transfer and return
to the main window.
5
After [Transfer completed] window
appears, click [OK] to close.
2
When "Main F/W update" windows appears on step 5, only transfer of install file from
MSA for Technician to printer is terminated but program installation to printer is not
terminated. DO NOT turn off the printer unless installation to printer is terminated.
After program installation completes, Main board buzzer rings 3 times.
NOTE
CAUTION
VJ628XE-M-00
201