Replacing Waste Fluid Box - MUTOH DrafStation RJ-901X Operation Manual

Maintenance
5.1.4

Replacing waste fluid box

This sub-section describes the replacement time and steps of waste fluid box.
（1） Replacement time
Replace waste fluid box when the following situation occurs.
a. If "NearFullWasteInkTank" is displayed on the operation panel
• Waste fluid box shortly becomes full.
• Printing operation continues.
•
Prepare a waste fluid box for replacement before the waste fluid box is full.
b. If "FullWasteInkTank" is displayed on the operation panel
• The waste fluid box is full.
• Printing operation stops.
• Immediately replace the waste fluid box.
（2） Type
The waste fluid box that can be used for the printer is as follows.
Description
Waste fluid box RJ9-HEB
（3） Replacing steps
Replace the waste fluid box according to the following steps.
1.
Check that the power to the printer is turned ON.
3.2.1 Turning the power ON
RJ-900X series OPERATION MANUAL
Model No.
RJ9-HEB
5-16