Mazda CX-7 2007 Workshop Manual page 1685

MAP LIGHT INSPECTION
1. Verify that the continuity between the map light
terminals is as indicated in the table.
• If not as indicated in the table, replace the
map light.
Switch position
MAP
INTERIOR
LIGHT LIGHT C
SWITCH
SWITCH
-
ON
-
DOOR
OFF OFF
End Of Sie
INTERIOR LIGHT BULB REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Insert a tape-wrapped flathead screwdriver into
the service hole and pry with the screwdriver in
the direction shown by the arrow to remove the
lens.
3. Remove the interior light bulb.
4. Install in the reverse order of removal.
End Of Sie
INTERIOR LIGHT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
(1) A-pillar lower trim (See 09-17-16 A-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)
(2) A-pillar trim (See 09-17-15 A-PILLAR TRIM REMOVAL/INSTALLATION.)
(3) Front scuff plate inner (See 09-17-19 FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
(4) Rear scuff plate inner (See 09-17-19 REAR SCUFF PLATE REMOVAL/INSTALLATION.)
(5) B-pillar lower trim (See 09-17-16 B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)
(6) Front seat belt upper anchor installation bolt (See 08-11-2 FRONT SEAT BELT REMOVAL/
INSTALLATION.)
(7) B-pillar upper trim (See 09-17-16 B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)
(8) Rear seat (See 09-13-7 REAR SEAT REMOVAL/INSTALLATION.)
(9) Sub trunk box (See 09-17-25 SUB TRUNK BOX REMOVAL/INSTALLATION.)
(10)Trunk end trim (See 09-17-24 TRUNK END TRIM REMOVAL/INSTALLATION.)
(11)Trunk side trim (See 09-17-24 TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
LIGHTING SYSTEMS
Bulb
:
Terminal
B A
EPU918ZW3018
B
MAP LIGHT
SWITCH (LH)
OFF
C
INTERIOR LIGHT
SWITCH
C
*
INTERIOR LIGHT
BULB
id091800801300
DOOR
MAP LIGHT
SWITCH (RH)
A
B A
EPU918ZW3017
id091800801400
SERVICE HOLE
acxuuw00001761
INTERIOR LIGHT
acxuuw00001762
id091800801500
09-18–23
09-18