Fetch[1][:Scalar][:Power:ac]? [<Expected_Value>[,<Resolution>[,<Source List>]]] - Agilent Technologies U2000 Series Manual

FETCh[1][:SCALar][:POWer:AC]?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the current window's measurement function with relative
mode off, recalculates the measurement and places the result on the bus. The
result is a power based measurement and is expressed in the units defined by
UNIT[1]:POWer.
Syntax
FETC
1
Parameters
Refer to
parameters in this command.
U2000 Series Programming Guide
:POW
:SCAL
expected_value
Space
DEF
"Optional Parameters"
Item Description/Default
expected_value The expected power level parameter can be
set to DEF or a numeric value. If a value is
(for the expected
power level) entered it should correspond to that set by
CONFigure otherwise an error occurs. The
units of measurement are dBm and W. The
default units are defined by UNIT:POWer.
:AC ?
,
resolution
DEF
on page 67 for additional details on the
MEASurement Commands
,
source list
Range of Values
–
60 dBm to +20 dBm
1
DEF
2
75