Setting Offsets
Channel Offsets
The power sensor can be configured to compensate for signal loss or gain in
your test setup (for example, to compensate for the loss of a 10 dB attenuator).
You use the SENSe command subsystem to configure the power sensor. Gain
and loss correction are a coupled system. If you enter an offset value the state
is automatically enabled. However it can be enabled and disabled using either
the [SENSe[1]]:CORRection:GAIN2:STATe.
To enter a LOSS value, you can enter a negative value in the command
N O T E
[SENSe[1]]:CORRection:GAIN2[:INPut][:MAGNitude]<numeric_value>.
U2000 Series Programming Guide
Power Sensor Remote Operation
1
27