Calculate[1]:Limit:clear:auto <Boolean>|Once - Agilent Technologies U2000 Series Manual

3 CALCulate Subsystem
CALCulate[1]:LIMit:CLEar:AUTo <boolean>|ONCE
This command controls when the FCO (fail counter) is cleared of any limit
failures. The FCO is used to determine the results returned by the
CALCulate[1]:LIMit:FAIL? query.
• If ON is specified, the FCO is set to 0 each time a measurement is:
• If OFF is specified, the FCO is not cleared by the above commands.
• If ONCE is specified, the FCO is cleared only after the first initialization
SyntaxExample
CALC1:LIM:CLE:AUTO 1
Reset Condition
On reset, measurement is set to ON.
90
Initiated using INITiate[:IMMediate]
•
Initiated using INITiate:CONTinuous ON
•
Measured using MEASure?
•
Read using READ?
•
then starts accumulating any limit failures.
CALC
1 :LIM
:CLE :AUTO
This command switches on automatic
clearing of the FCO for the current
window/measurement.
U2000 Series Programming Guide
Space 0|OFF
1|ON
ONCE
?