Editing Frequency Dependent Offset Tables - Agilent Technologies U2000 Series Manual

Editing Frequency Dependent Offset Tables

It is not possible to create any additional frequency dependent offset tables.
However, the 10 existing tables can be edited using the MEMory subsystem. To
do this:
1 Select one of the existing tables using:
2 Enter the frequency data using:
3 Enter the offset factors as shown in the table below using:
4 If required, rename the frequency dependent offset table using:
U2000 Series Programming Guide
MEMory:TABle:SELect <string>
For information on naming frequency dependent offset tables see
Frequency Dependent Offset Tables"
current names which you can select refer to
Dependent Offset Table Names"
MEMory:TABle:FREQuency <numeric_value> {,<numeric_value>}
MEMory:TABle:GAIN <numeric_value> {,<numeric_value>}
Frequency
Frequency 1
Frequency 2
"
Frequency n
MEMory:TABLe:MOVE <string>,<string>. The first <string> parameter
identifies the existing table name, and the second identifies the new table
name.
Power Sensor Remote Operation
on page 21. For information on the
"Listing the Frequency
on page 20.
Offset
Offset 1
Offset 2
"
Offset n
1
"Naming
19