Agilent Technologies U2000 Series Manual page 172

6 MEMory Subsystem
Query Example
MEM:TABL:GAIN?
Error Messages
• If more than 80 offsets for frequency dependent offset tables are in the list,
• If a table is not specified using the MEMory:TABLe:SELect command, the
• If any of the offset factors are outside of the allowed range, error –222,
154
error –108, "Parameter not allowed" occurs.
data cannot be entered and error –221, "Settings conflict" occurs.
"Data out of range" occurs.
This command queries the offset in the
current table.
U2000 Series Programming Guide