Table 1-1
WARNING
Power Meter and Sensor Cable Requirements
The P-Series Wideband Power Sensors are ONLY compatible with the P-Series
Power Meters.
Table 1-1 lists the length of cable option, these have no interconnecting cable
requirements, as the cable is permanently connected (hard-wired) to the P-Series
Wideband power sensor.
Cable Length Options
Option
N1921A-105
N1922A-105
N1921A-106
N1922A-106
N1921A-107
N1922A-107
Interconnections
Connect the cable to the P-Series power meter's channel input. Figure 1-2 shows
that you must align the red dot on the sensor's cable and the meter's connector.
BEFORE CONNECTING THE POWER SENSOR TO OTHER
INSTRUMENTS ensure that all instruments are connected to the protective
(earth) ground. Any interruption of the protective earth grounding will cause a
potential shock hazard that could result in personal injury.
Recommended Calibration Interval
Agilent Technologies recommends a one-year calibration cycle for the P-Series
power sensors.
4
Description
1.5m (5-ft) cable length
3m (10-ft) cable length
10m (31-ft) cable length