Table of Contents
Advertisement
ABORt[1]
This command removes the sensor from the wait for trigger state and places it
in the idle state. It does not affect any other settings of the trigger system.
When the INITiate command is sent, the trigger system responds as it did
before ABORt was executed.
If INITiate:CONTinuous is ON, then after ABORt the current measurement
immediately goes into the wait for trigger state.
Syntax
Example
ABOR
U2000 Series Programming Guide
ABOR
1
This command places the sensor in the
idle state.
TRIGger Subsystem
263
11
Hide quick links:
Advertisement
Table of Contents
