Table 1-1 Measure? And Configure Preset States; Making Measurement - Agilent Technologies U2000 Series Manual

Making Measurement

The MEASure? and CONFigure commands provide a straight- forward method
to program the power sensor for measurements. You can select the
measurement's expected power level and resolution all in one command. The
power sensor automatically presets other measurement parameters to default
values as shown in

Table 1-1 MEASure? and CONFigure Preset States

An alternative method to program the power sensor is to use the lower level
commands. The advantage of using the lower level commands over the
CONFigure command is that they give you more precise control of the power
sensor. As shown in
states in the power sensor. It may be likely that you do not want to preset
these states. Refer to
further information.
U2000 Series Programming Guide
Table 1- 1
Command
Trigger source
(TRIGger:SOURce)
Filter
([SENSe[1]]:AVERage:COUNt:AU
TO)
Filter
state([SENSe[1]]:AVERage:STATe
)
Trigger cycle
(INITiate:CONTinuous)
TriggerDelay
(TRIGger:DELay:AUTO)
Table 1-
below.
MEASure? and CONFigure Setting
Immediate
On
On
Off
On
1, the CONFigure command presets various
"Using the Lower Level Commands"
Power Sensor Remote Operation
on page 15 for
1
7