12
UNIT Subsystem
UNIT Subsystem
The UNIT command subsystem:
• Sets power measurement units to dBm or Watts.
This UNIT command has a numeric suffix which determines which
window/measurement is set:
Figure 12-1 Measurement Display UNIT Block Window
The following commands are described in this section:
The UNIT:POWer command is as follows:
• If UNIT:POWer is set to dBm.
• If UNIT:POWer is set to W.
292
current window/measurement
Keyword
UNIT[1]
:POWer
UNIT1
Parameter Form
<amplitude unit>
Notes
Page
page 293
U2000 Series Programming Guide