Calculate[1]:Limit:fail - Agilent Technologies U2000 Series Manual

CALCulate[1]:LIMit:FAIL?

This query enters a 1 or 0 into the output buffer indicating whether there have
been any limit failures for the current window. A limit failure is defined as
CALC[1]:LIMit:FCO? being non- zero. The FCO (fail counter) can be zeroed
using the CALC[1]:LIMit:CLEar command.
• 1 is returned when one or more limit failures have occurred
• 0 is returned when no limit failures have occurred
Syntax
Example
CALC1:LIM:FAIL?
Reset Condition
On reset, the buffer is set to zero for the current window measurements.
U2000 Series Programming Guide
CALC 1 :LIM :FAIL ?
This command queries if there have been
any limit failures on the current
window/measurement.
CALCulate Subsystem 3
93