Read[1] Commands - Agilent Technologies U2000 Series Manual

READ[1] Commands

The READ? commands are most commonly used with the CONFigure
command to cause a new power measurement to be taken and the result
returned to the output buffer. The format of the result is set by
FORM[:READ][:DATA]. Refer to
for further information.
• The READ? query is equivalent to:
U2000 Series Programming Guide
ABORt
INITiate
FETCh?
or
ABORt1
INITiate1
FETCh1?
MEASurement Commands
Chapter 5, "FORMat Subsystem," on page 119
2
77