Scpi Compliance Information - Agilent Technologies U2000 Series Manual

1 Power Sensor Remote Operation

SCPI Compliance Information

The power sensor complies with the rules and regulations of the present
version of SCPI (Standard Commands for Programmable Instruments). You
can determine the SCPI version with which the power sensor's is in
compliance by sending the SYSTem:VERSion? command from the remote
interface.
The following commands are device- specific to the power sensor. They are not
included in the 1999.0 version of the SCPI standard. However, these
commands are designed with the SCPI format in mind and they follow all of
the syntax rules of the standard.
MEMory:CLEar[:NAME]
MEMory:TABLe:SELect
MEMory:STATe:DEFine
MEMory:TABLe:GAIN[:MAGNitude]
MEMory:TABLe:GAIN:POINts?
MEMory:TABLe:MOVE
[SENSe[1]]:AVERage:SDETect
[SENSe[1]]:CORRection:FDOFfset
[SENSe[1]]:MRATe
[SENSe[1]]:POWer:AC:RANGe
SERVice:SENSor[1]:CDATE?
SERVice:SENSor[1]:CPLace?
SERVice:SENSor[1]:SNUMber?
SERVice:SENSor[1]:TYPE?
62 U2000 Series Programming Guide