Agilent Technologies U2000 Series Manual page 109

Query
CALCulate[1]:LIMit:CLEar:AUTO?
The query command enters a 1 or 0 into the output buffer indicating whether
limit failures are cleared automatically when a new measurement is initiated
on the current window section.
• 1 is entered into the output buffer when limit failures are cleared
• 0 is entered into the output buffer when limit failures are not cleared
In the case where limit failures are cleared once, when a query occurs a 1 is
entered into the output buffer if no measurement is initiated. If a
measurement is initiated then 0 is entered.
Query Example
CALC1:LIM:CLE:AUTO?
U2000 Series Programming Guide
automatically when a new measurement is initiated.
automatically when a new measurement is initiated.
This command queries when the FCO is
cleared for the current
window/measurement.
CALCulate Subsystem 3
91